E32-R16 datasheet(105/108 Pages) OMRON

105 / 108 page

E32

106

Installation

SENSING HEAD

Mounting Sensing Head in a Panel

Prepare a hole in the panel that can accommodate the threaded

cylindrical sensing head. Be sure to place the washer in front of

the mounting nut before inserting the sensing head through the

hole. Tighten the front mounting nut using no more than the

maximum torque recommended in the table.

Spring mountingclip

Toothed washers

Nuts

(attachment)

Mounting Sensing Head in a Channel

Insert the sensing head at the desired location in the channel as

shown in the illustration, then use a set screw to fasten the head

in place. Apply no more than 2.6 in-lb of force in tightening the

set screw.

Retaining screw

(M 3 max.)

Tightening Torque

Use a proper-sized

wrench and do not

exceed the torque

recommended for the

sensing head.

Sensing heads

Maximum torque

M3 and M4 threads

M6 threads

6.88 in-lb

8.66 in-lb

2 mm dia., no thread

3 mm dia., no thread

2.6 in-lb

E32-D14L

E32-T12F

8.66 in-lb

6.88 in-lb

E32-D12F

E32-T16

6.88 in-lb

4.33 in-lb

E32-R21

E32-M21

E32-L25A

5.2 in-lb

4.33 in-lb

6.88 in-lb

CUTTING FIBER

Insert a fiber into the Fiber and determine the length of the fiber

to be cut.

Press down the Fiber Cutter in a single stroke to cut the fiber.

When the fiber is cut, an insertion mark is inscribed on the fiber.

12.6

Insertion mark

2.2-dia.

For a 2.2-mm dia. standard fiber only.

Insert a fiber into the Fiber Cutter in the direction indicated by the

arrow (refer to the following figure).

The cutting holes cannot be used twice. If the same hole is used

twice, the cutting face of the fiber will be rough and the sensing

distance will be reduced. Always use an unused hole.

Use either one of the two holes on the right (refer to the following

figure) to cut a thin fiber as follows:

1. An attachment is temporarily fitted to a thin fiber before

shipment.

Temporarily fitted

2. Secure the attachment after adjusting the position of it in the

direction indicated by the arrow.

3. Insert the fiber into the E39-F4 to cut.

Three holes for

standard fiber

(2.2 mm dia.)

Cutter E39-F4

Two holes for

thin fiber

Note: Insert the fiber in the direction indicated by the arrow.

E32-R16 Datasheet(PDF) 105 Page - Omron Electronics LLC

E32-R16 Datasheet(HTML) 105 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL