PIC18F4520ESLASHMLQTP datasheet(168/390 Pages) MICROCHIP

168 / 390 page

PIC18F2420/2520/4420/4520

DS39631A-page 166

Preliminary

 2004 Microchip Technology Inc.

17.3.5

MASTER MODE

The master can initiate the data transfer at any time

because it controls the SCK. The master determines

when the slave (Processor 2, Figure 17-2) is to

broadcast data by the software protocol.

In Master mode, the data is transmitted/received as

soon as the SSPBUF register is written to. If the SPI is

only going to receive, the SDO output could be dis-

abled (programmed as an input). The SSPSR register

will continue to shift in the signal present on the SDI pin

at the programmed clock rate. As each byte is

received, it will be loaded into the SSPBUF register as

if a normal received byte (interrupts and status bits

appropriately set). This could be useful in receiver

applications as a “Line Activity Monitor” mode.

The clock polarity

is selected by appropriately

programming the CKP bit (SSPCON1<4>). This then,

would give waveforms for SPI communication as

shown in Figure 17-3, Figure 17-5 and Figure 17-6,

where the MSB is transmitted first. In Master mode, the

SPI clock rate (bit rate) is user programmable to be one

of the following:

•FOSC/4 (or TCY)

•FOSC/16 (or 4 • TCY)

•FOSC/64 (or 16 • TCY)

• Timer2 output/2

This allows a maximum data rate (at 40 MHz) of

10.00 Mbps.

Figure 17-3 shows the waveforms for Master mode.

When the CKE bit is set, the SDO data is valid before

there is a clock edge on SCK. The change of the input

sample is shown based on the state of the SMP bit. The

time when the SSPBUF is loaded with the received

data is shown.

FIGURE 17-3:

SPI MODE WAVEFORM (MASTER MODE)

SCK

(CKP = 0

SCK

(CKP = 1

SCK

(CKP = 0

SCK

(CKP = 1

4 Clock

Modes

Input

Sample

Input

Sample

SDI

bit 7

bit 0

SDO

bit 7

bit 6

bit 5

bit 4

bit 3

bit 2

bit 1

bit 0

bit 7

SDI

SSPIF

(SMP = 1)

(SMP = 0)

(SMP = 1)

CKE = 1)

CKE = 0)

CKE = 1)

CKE = 0)

(SMP = 0)

Write to

SSPBUF

SSPSR to

SSPBUF

SDO

bit 7

bit 6

bit 5

bit 4

bit 3

bit 2

bit 1

bit 0

(CKE = 0)

(CKE = 1)

Next Q4 Cycle

after Q2

↓

bit 0

PIC18F4520E/MLQTP Datasheet(PDF) 168 Page - Microchip Technology

PIC18F4520E/MLQTP Datasheet(HTML) 168 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL