MCIMX6DP4AVT2AB datasheet(131/160 Pages) NXP

131 / 160 page

Electrical Characteristics

i.MX 6DualPlus/6QuadPlus Applications Processors Industrial Products, Rev. 3, 11/2018

NXP Semiconductors

131

4.12.22 USB PHY Parameters

This section describes the USB-OTG PHY and the USB Host port PHY parameters.

The USB PHY meets the electrical compliance requirements defined in the Universal Serial Bus Revision

2.0 OTG, USB Host with the amendments below (On-The-Go and Embedded Host Supplement to the USB

Revision 2.0 Specification is not applicable to Host port).

•

USB ENGINEERING CHANGE NOTICE

— Title: 5V Short Circuit Withstand Requirement Change

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

Errata for USB Revision 2.0 April 27, 2000 as of 12/7/2000

•

USB ENGINEERING CHANGE NOTICE

— Title: Pull-up/Pull-down resistors

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

USB ENGINEERING CHANGE NOTICE

— Title: Suspend Current Limit Changes

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

USB ENGINEERING CHANGE NOTICE

— Title: USB 2.0 Phase Locked SOFs

— Applies to: Universal Serial Bus Specification, Revision 2.0

•

On-The-Go and Embedded Host Supplement to the USB Revision 2.0 Specification

— Revision 2.0 plus errata and ecn June 4, 2010

•

Battery Charging Specification (available from USB-IF)

— Revision 1.2, December 7, 2010

— Portable device only

MCIMX6DP4AVT2AB Datasheet(PDF) 131 Page - NXP Semiconductors