SH7041A datasheet(616/923 Pages) RENESAS

616 / 923 page

578

16.4.2

Scan Mode (SCAN=1)

The scan mode is optimal for monitoring analog input of multiple channels (including channel 1).

A/D conversion is started from channel 1 (AN0 for A/D0 and AN4 for A/D1) of the group when

the ADST bit of the A/D control/status register (ADCSR) is set to 1 by the software or external

trigger input.

When multiple channels are selected, A/D conversion of channel 2 (AN1 or AN5) is initiated

immediately after completion of the channel 1 conversion.

To switch modes or analog input channels during A/D conversion, clear the ADST bit to 0 and

stop A/D conversion to avoid malfunction. After switching (mode/channel change and ADST bit

setting can be made at the same time), set ADST bit to 1 to restart A/D conversion from channel 1.

An example of operation when three channels of A/D0 (AN0–2) are selected for A/D conversion

is shown in figure 16.4 (the bit specification in the example is the ADCSR0 register).

Set operation mode to scan mode (SCAN=1), set analog channels to AN0–2 (CH1=1, CH0=0)

then start A/D conversion (ADST=1).

2. When A/D conversion for channel 1 is complete, A/D conversion result is transferred to

ADDRA0.

Next, channel 2 (AN1) will automatically be selected and conversion will begin.

In the same manner, channel 3 will be converted (AN2).

When conversion of all of the selected channels (AN0–AN2) are complete, ADF will become

1 and channel 1 (AN0) will again be selected and conversion will begin.

At this time, if the ADIE bit is set to 1, ADI interrupt request will occur after completing A/D

conversion.

5. Steps (2) to (4) will be repeated while ADST bit is set to 1.

A/D conversion will stop when setting the ADST bit to 0. When setting the ADST bit to 1,

A/D conversion will start again from channel 1 (AN0).

SH7041A Datasheet(PDF) 616 Page - Renesas Technology Corp