TMPR4925 datasheet(175/590 Pages) TOSHIBA

175 / 590 page

Chapter 8 DMA Controller

8-5

Figure 8.3.1 External I/O DMA Transfer (Single Address, Level Request)

8.3.3.2

Dual Address Transfer

If the Single Address bit (DMCCRn.SNGAD) has been cleared, access to external I/O devices

and to external memory is each performed continuously. Each access is the same as normal access

except when the DMAACK[n] signal is asserted.

Please refer to “8.3.8 Dual Address Transfer” for information regarding setting the register.

8.3.3.3

Single Address Transfer (Fly-by DMA)

If the Single Address bit (DMCCRn.SNGAD) is set, either data reading from an external I/O

device and data writing to external memory or data reading from external memory and data

writing to an external I/O device is performed simultaneously. The following conditions must be

met in order to perform Single Address transfer.

•

The data bus widths of the external I/O device and external memory match

•

Data can be input/output to/from the external I/O device and external memory during the

same clock cycle

The Transfer Direction bit (MEMIO) of the DMA Channel Control Register (DMCCRn)

specifies the transfer direction.

•

From memory to an external I/O device (DMCCRn.MEMIO = “1”)

External memory Read operation to an address specified by the DMA Source Address

1c040

SYSCLK

CE*

ADDR [19:0]

ACE*

OE*/BUSSPRT*

SWE*

BWE*

DATA [31:0]

ACK*

DMAREQ[n]

DMAACK[n]

DMADONE*

00040

00000100

1 cycle

TMPR4925 Datasheet(PDF) 175 Page - Toshiba Semiconductor