TMP86FS49BUG datasheet(243/294 Pages) TOSHIBA

243 / 294 page

Page 227

TMP86FS49BUG

It takes a maximum of 40

µs to set security program in the flash memory. The next command sequence can-

not be executed until this operation is completed. To check the completion of the security program operation,

perform read operations repeatedly for data polling until the same data is read twice from the same address in

the flash memory. During the security program operation, any attempts to read from the same address is

reversed bit 6 of the data (toggling between 0 and 1).

19.3 Toggle Bit (D6)

After the byte program, chip erase, and security program command sequence is executed, any consecutive

attempts to read from the same address is reversed bit 6 (D6) of the data (toggling between 0 and 1) until the opera-

tion is completed. Therefore, this toggle bit provides a software mechanism to check the completion of each opera-

tion. Usually perform read operations repeatedly for data polling until the same data is read twice from the same

address in the flash memory. After the byte program, chip erase, or security program command sequence is executed,

the initial read of the toggle bit always produces a "1".

TMP86FS49BUG Datasheet(PDF) 243 Page - Toshiba Semiconductor