HD6432351 datasheet(608/1025 Pages) RENESAS

608 / 1025 page

Section 13 Serial Communication Interface (SCI)

Rev. 3.00 Sep 15, 2006 page 574 of 988

REJ09B0330-0300

13.3

Operation

13.3.1

Overview

The SCI can carry out serial communication in two modes: asynchronous mode in which

synchronization is achieved character by character, and clocked synchronous mode in which

synchronization is achieved with clock pulses.

Selection of asynchronous or clocked synchronous mode and the transmission format is made

using SMR as shown in table 13.8. The SCI clock is determined by a combination of the C/

A bit

in SMR and the CKE1 and CKE0 bits in SCR, as shown in table 13.9.

Asynchronous Mode

• Data length: Choice of 7 or 8 bits

• Choice of parity addition, multiprocessor bit addition, and addition of 1 or 2 stop bits (the

combination of these parameters determines the transfer format and character length)

• Detection of framing, parity, and overrun errors, and breaks, during reception

• Choice of internal or external clock as SCI clock source

 When internal clock is selected:

The SCI operates on the baud rate generator clock and a clock with the same frequency as

the bit rate can be output

 When external clock is selected:

A clock with a frequency of 16 times the bit rate must be input (the on-chip baud rate

generator is not used)

Clocked Synchronous Mode

• Transfer format: Fixed 8-bit data

• Detection of overrun errors during reception

• Choice of internal or external clock as SCI clock source

 When internal clock is selected:

The SCI operates on the baud rate generator clock and a serial clock is output off-chip

 When external clock is selected:

The on-chip baud rate generator is not used, and the SCI operates on the input serial clock

HD6432351 Datasheet(PDF) 608 Page - Renesas Technology Corp