M32CSLASH86 datasheet(479/505 Pages) RENESAS

479 / 505 page

Page 456

)

(

27.5 Clock Generation Circuit

27.5.1 CPU Clock

• When the CPU operating frequency is 24 MHz or more, use the following procedure for better EMC

(Electromagnetic Compatibility) performance.

1) Oscillator connected between the XIN and XOUT pins, or external clock applied to the

XIN pin, has less than 24 MHz frequency.

2) Use the PLL frequency synthesizer to multiply the main clock.

• In M32C/86T, the main clock frequency must be 24 MHz or less.

27.5.2 Sub Clock

Set the CM03 bit to "0" (XCIN-XCOUT drive capacity "LOW") when selecting the sub clock (XCIN-XCOUT) as

the CPU clock, or Timer A or Timer B count source (fC32).

27.5.2.1 Sub Clock Oscillation

When oscillating the sub clock, set the CM04 bit in the CM0 register to "1" (XCIN-XCOUT oscillation

function) after setting the CM07 bit in the CM0 register to "0" (clock other than sub clock) and the

CM03 bit to "1" (XCIN-XCOUT drive capacity "HIGH"). Set the CM03 bit to "0" after sub clock oscillation

stabilizes.

Set the sub clock as the CPU clock, or Timer A or Timer B count source (fC32) after the above settings

are completed.

27.5.2.2 Using Stop Mode

When the microcomputer enters stop mode, the CM03 bit is automatically set to "1" (XCIN-XCOUT drive

capacity "HIGH"). Use the following procedure to select the main clock as the CPU clock when enter-

ing stop mode.

1) Set the CM17 bit in the CM1 register to "0" (main clock).

2) Set the CM21 bit in the CM2 register to "0" (clock selected by the CM17 bit).

3) Set the CM07 bit in the CM0 register to "0" (clock selected by the CM21 bit divided by the MCD

After exiting stop mode, wait for the sub clock oscillation to stabilize. Then set the CM03 bit to "0" and

the CM07 bit to "1" (sub clock).

27.5.2.3 Oscillation Parameter Matching

If the sub slock oscillation parameters have only been evaluated with the drive capacity "HIGH", the

parameters should be reevaluated for drive capacity "LOW".

Contact your oscillator manufacturer for details on matching parameters.

27. Precautions (Clock Generation Circuit)

M32C/86 Datasheet(PDF) 479 Page - Renesas Technology Corp