AT90SCR100 datasheet(313/433 Pages) ATMEL

313 / 433 page

313

TPR0327AY–SMS–30Jan09

AT90SCR100

Figure 22-13.

Data Transfer in Master Receiver Mode

A START condition is sent by writing the following value to TWCR:

TWEN must be written to one to enable the 2-wire Serial Interface, TWSTA must be written to

one to transmit a START condition and TWINT must be set to clear the TWINT Flag. The TWI

will then test the 2-wire Serial Bus and generate a START condition as soon as the bus

becomes free. After a START condition has been transmitted, the TWINT Flag is set by hard-

ware, and the status code in TWSR will be 0x08 (See Table 22-2). In order to enter MR mode,

SLA+R must be transmitted. This is done by writing SLA+R to TWDR. Thereafter the TWINT bit

should be cleared (by writing it to one) to continue the transfer. This is accomplished by writing

the following value to TWCR:

When SLA+R have been transmitted and an acknowledgement bit has been received, TWINT is

set again and a number of status codes in TWSR are possible. Possible status codes in Master

mode are 0x38, 0x40, or 0x48. The appropriate action to be taken for each of these status codes

is detailed in Table 22-3. Received data can be read from the TWDR Register when the TWINT

Flag is set high by hardware. This scheme is repeated until the last byte has been received.

After the last byte has been received, the MR should inform the ST by sending a NACK after the

last received data byte. The transfer is ended by generating a STOP condition or a repeated

START condition. A STOP condition is generated by writing the following value to TWCR:

A REPEATED START condition is generated by writing the following value to TWCR:

Please note that R1 and R2 resistors may be useless. Indeed, internal pull-up

resistors on SDA and SCL pads of AVR may be sufficient to setup a communica-

tion. Anyway, R1 and R2 are welcomed if the edges are not strong enough to get a

clean signals.

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

value

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

value

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

value

TWCR

TWINT

TWEA

TWSTA

TWSTO

TWWC

TWEN

–

TWIE

Device 1

MASTER

RECEIVER

Device 2

SLAVE

TRANSMITTER

Device 3

Device n

SDA

SCL

........

Note

AT90SCR100 Datasheet(PDF) 313 Page - ATMEL Corporation

AT90SCR100 Datasheet(HTML) 313 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL