PIC16F1508TESSQTO datasheet(180/384 Pages) MICROCHIP

180 / 384 page

PIC16(L)F1508/9

DS41609A-page 180

Preliminary

 2011 Microchip Technology Inc.

20.1

Timer2 Operation

The clock input to the Timer2 module is the system

instruction clock (FOSC/4).

TMR2 increments from 00h on each clock edge.

A 4-bit counter/prescaler on the clock input allows direct

input, divide-by-4 and divide-by-16 prescale options.

These options are selected by the prescaler control bits,

T2CKPS<1:0> of the T2CON register. The value of

TMR2 is compared to that of the Period register, PR2, on

each clock cycle. When the two values match, the

comparator generates a match signal as the timer

output. This signal also resets the value of TMR2 to 00h

on the next cycle and drives the output counter/

postscaler (see Section 20.2 “Timer2 Interrupt”).

The TMR2 and PR2 registers are both directly readable

and writable. The TMR2 register is cleared on any

device Reset, whereas the PR2 register initializes to

FFh. Both the prescaler and postscaler counters are

cleared on the following events:

• a write to the TMR2 register

• a write to the T2CON register

• Power-on Reset (POR)

• Brown-out Reset (BOR)

•MCLR Reset

• Watchdog Timer (WDT) Reset

• Stack Overflow Reset

• Stack Underflow Reset

• RESET Instruction

20.2

Timer2 Interrupt

Timer2 can also generate an optional device interrupt.

The Timer2 output signal (TMR2-to-PR2 match)

provides the input for the 4-bit counter/postscaler. This

counter generates the TMR2 match interrupt flag which

is latched in TMR2IF of the PIR1 register. The interrupt

is enabled by setting the TMR2 Match Interrupt Enable

bit, TMR2IE of the PIE1 register.

A range of 16 postscale options (from 1:1 through 1:16

inclusive) can be selected with the postscaler control

bits, T2OUTPS<3:0>, of the T2CON register.

20.3

Timer2 Output

The unscaled output of TMR2 is available primarily to

the PWMx module, where it is used as a time base for

operation.

20.4

Timer2 Operation During Sleep

Timer2 cannot be operated while the processor is in

Sleep mode. The contents of the TMR2 and PR2

registers will remain unchanged while the processor is

in Sleep mode.

Note:

TMR2 is not cleared when T2CON is

written.

PIC16F1508TESSQTO Datasheet(PDF) 180 Page - Microchip Technology

PIC16F1508TESSQTO Datasheet(HTML) 180 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL