PIC24FJ128GA310 datasheet(143/406 Pages) MICROCHIP

143 / 406 page

 2010-2011 Microchip Technology Inc.

DS39996F-page 143

PIC24FJ128GA310 FAMILY

8.4

Interrupt Setup Procedures

8.4.1

INITIALIZATION

To configure an interrupt source:

Set the NSTDIS (INTCON1<15>) control bit if

nested interrupts are not desired.

Select the user-assigned priority level for the

interrupt source by writing the control bits in the

appropriate IPCx register. The priority level will

depend on the specific application and type of

interrupt source. If multiple priority levels are not

desired, the IPCx register control bits for all

enabled interrupt sources may be programmed

to the same non-zero value.

Clear the interrupt flag status bit associated with

the peripheral in the associated IFSx register.

Enable the interrupt source by setting the

interrupt enable control bit associated with the

source in the appropriate IECx register.

8.4.2

INTERRUPT SERVICE ROUTINE

(ISR)

The method that is used to declare an Interrupt Service

Routine (ISR) and initialize the IVT with the correct vec-

tor address will depend on the programming language

(i.e., ‘C’ or assembler) and the language development

toolsuite that is used to develop the application. In

general, the user must clear the interrupt flag in the

appropriate IFSx register for the source of the interrupt

that the ISR handles; otherwise, the ISR will be

re-entered immediately after exiting the routine. If the

ISR is coded in assembly language, it must be termi-

nated using a RETFIE instruction to unstack the saved

PC value, SRL value and old CPU priority level.

8.4.3

TRAP SERVICE ROUTINE (TSR)

A Trap Service Routine (TSR) is coded like an ISR,

except that the appropriate trap status flag in the

INTCON1 register must be cleared to avoid re-entry

into the TSR.

8.4.4

INTERRUPT DISABLE

All user interrupts can be disabled using the following

procedure:

Push the current SR value onto the software

stack using the PUSH instruction.

Force the CPU to Priority Level 7 by inclusive

ORing the value 0Eh with SRL.

To enable user interrupts, the POP instruction may be

used to restore the previous SR value.

Note that only user interrupts with a priority level of 7 or

less can be disabled. Trap sources (Level 8-15) cannot

be disabled.

The DISI instruction provides a convenient way to

disable interrupts of Priority Levels 1-6 for a fixed

period of time. Level 7 interrupt sources are not

disabled by the DISI instruction.

Note:

At a device Reset, the IPCx registers are

initialized, such that all user interrupt

sources are assigned to Priority Level 4.

PIC24FJ128GA310 Datasheet(PDF) 143 Page - Microchip Technology

PIC24FJ128GA310 Datasheet(HTML) 143 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL