PIC16F882-I datasheet(130/328 Pages) MICROCHIP

130 / 328 page

PIC16F882/883/884/886/887

DS41291F-page 128

11.5

PWM Mode

The PWM mode generates a Pulse-Width Modulated

signal on the CCPx pin. The duty cycle, period and

resolution are determined by the following registers:

•PR2

•T2CON

• CCPRxL

• CCPxCON

In Pulse-Width Modulation (PWM) mode, the CCP

module produces up to a 10-bit resolution PWM output

on the CCPx pin. Since the CCPx pin is multiplexed

with the PORT data latch, the TRIS for that pin must be

cleared to enable the CCPx pin output driver.

Figure 11-3 shows a simplified block diagram of PWM

operation.

Figure 11-4 shows a typical waveform of the PWM

signal.

For a step-by-step procedure on how to set up the CCP

module for PWM operation, see Section 11.5.7

“Setup for PWM Operation”.

FIGURE 11-3:

SIMPLIFIED PWM BLOCK

DIAGRAM

The PWM output (Figure 11-4) has a time base

(period) and a time that the output stays high (duty

cycle).

FIGURE 11-4:

CCP PWM OUTPUT

Note:

Clearing

the

CCPxCON

will

relinquish CCPx control of the CCPx pin.

CCPRxL

CCPRxH(2) (Slave)

Comparator

TMR2

PR2

(1)

Duty Cycle Registers

CCPxCON<5:4>

Clear Timer2,

toggle CCPx pin and

latch duty cycle

Note

The 8-bit timer TMR2 register is concatenated

with the 2-bit internal system clock (FOSC), or

2 bits of the prescaler, to create the 10-bit time

base.

In PWM mode, CCPRxH is a read-only register.

TRIS

CCPx

Comparator

Period

Pulse Width

TMR2 = 0

TMR2 = CCPRxL:CCPxCON<5:4>

TMR2 = PR2

PIC16F882-I Datasheet(PDF) 130 Page - Microchip Technology

PIC16F882-I Datasheet(HTML) 130 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL