PIC17C752-08SLASHCL datasheet(152/328 Pages) MICROCHIP

152 / 328 page

PIC17C7XX

DS30289A-page 152

15.2.9

I2C MASTER MODE START CONDITION

TIMING

To initiate a START condition the user sets the start

condition enable bit, SEN (SSPCON2<0>). If the SDA

and SCL pins are sampled high, the baud rate genera-

tor is re-loaded with the contents of SSPADD<6:0>,

and starts its count. If SCL and SDA are both sampled

high when the baud rate generator times out (TBRG),

the SDA pin is driven low. The action of the SDA being

driven low while SCL is high is the START condition,

and causes the S bit (SSPSTAT<3>) to be set. Follow-

ing this, the baud rate generator is reloaded with the

contents of SSPADD<6:0> and resumes its count.

When the baud rate generator times out (TBRG) the

SEN bit (SSPCON2<0>) will be automatically cleared

by hardware, the baud rate generator is suspended

leaving the SDA line held low, and the START condition

is complete.

Note:

If at the beginning of START condition the

SDA and SCL pins are already sampled

low, or if during the START condition the

SCL line is sampled low before the SDA

line is driven low, a bus collision occurs, the

Bus Collision Interrupt Flag (BCLIF) is set,

the START condition is aborted, and the

I2C module is reset into its IDLE state.

15.2.9.1

WCOL STATUS FLAG

If the user writes the SSPBUF when an START

sequence is in progress, then WCOL is set and the

contents of the buffer are unchanged (the write doesn’t

occur).

Note:

Because

queueing

events

not

allowed, writing to the lower 5 bits of

SSPCON2 is disabled until the START

condition is complete.

FIGURE 15-23: FIRST START BIT TIMING

SDA

SCL

BRG

1st Bit

2nd Bit

BRG

SDA = 1,

At completion of start bit,

SCL = 1

Write to SSPBUF occurs here

BRG

Hardware clears SEN bit

BRG

Write to SEN bit occurs here.

Set S bit (SSPSTAT<3>)

and sets SSPIF bit

PIC17C752-08/CL Datasheet(PDF) 152 Page - Microchip Technology

PIC17C752-08/CL Datasheet(HTML) 152 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL