| Electronic Components Datasheet Search |
|
ST72321R7-Auto Datasheet(PDF) 224 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST72321R7-Auto Datasheet(HTML) 224 Page - STMicroelectronics |
|
224 / 243 page ![]() Device configuration and ordering information ST72321xx-Auto 224/243 Doc ID 13829 Rev 1 Table 141. Option byte 0 bit description Bit Name Function OPT7 WDG HALT Watchdog and Halt mode This option bit determines if a RESET is generated when entering Halt mode while the Watchdog is active. 0: No Reset generation when entering Halt mode 1: Reset generation when entering Halt mode OPT6 WDG SW Hardware or software watchdog This option bit selects the watchdog type. 0: Hardware (watchdog always enabled) 1: Software (watchdog to be enabled by software) OPT5 - Reserved, must be kept at default value. OPT4:3 VD[1:0] Voltage detection These option bits enable the voltage detection block (LVD and AVD) with a selected threshold for the LVD and AVD (EVD + AVD). 00: Selected LVD = Highest threshold (VDD~4V) 01: Selected LVD = Medium threshold (VDD~3.5V) 10: Selected LVD = Lowest threshold (VDD~3V) 11: LVD and AVD off Caution: If the medium or low thresholds are selected, the detection may occur outside the specified operating voltage range. Below 3.8V, device operation is not guaranteed. For details on the AVD and LVD threshold levels refer to Table 19.3.2: Operating conditions with low voltage detector (LVD). OPT2 - Reserved, must be kept at default value. OPT1 PKG0 Package selection bit 0 This option bit is used with the PKG1 bit to select the package (see Table 143: Package selection (OPT7)). OPT0 FMP_R Flash memory readout protection Readout protection, when selected, provides a protection against program memory content extraction and against write access to Flash memory. Erasing the option bytes when the FMP_R option is selected causes the whole user memory to be erased first, after which the device can be reprogrammed. Refer to Section 4.3.1: Readout protection on page 30 and the ST7 Flash Programming Reference Manual for more details. Note: Readout protection is not supported if LVD is enabled. 0: Readout protection enabled 1: Readout protection disabled |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |