Electronic Components Datasheet Search
  New Zealand  ▼
ALLDATASHEET.CO.NZ

X  

  • M24C08-RMB3T

  • AI
    The **M24C08-RMB3TG** is a specific variant of an 8-Kbit serial I2C EEPROM (Electrically Erasable Programmable Read-Only Memory) manufactured by **STMicroelectronics**. It is widely used for non-volatile parameter storage in compact electronic devices. --- ### 1. Key Technical Specifications | Parameter | Specification | | :--- | :--- | | **Memory Size** | 8 Kbit (1024 x 8 bits) | | **Interface** | I2C (Inter-Integrated Circuit) | | **Operating Voltage** | 1.8V to 5.5V | | **Clock Frequency** | 400 kHz (Fast Mode) | | **Package Type** | UFDFPN8 (Ultra-thin Fine pitch Dual Flat No-lead) | | **Operating Temp** | -40°C to +125°C | | **Endurance** | 4 million write cycles | | **Data Retention** | 200 years | --- ### 2. Functional Description The device is organized as four blocks of 256 bytes (4 x 256 bytes). Since it is an I2C device, it operates as a **Slave** on the bus. #### Memory Addressing The 8-Kbit memory requires a 10-bit binary address. In the I2C protocol, this is handled as follows: * The 7-bit Device Select code contains fixed bits (`1010`) and dynamic bits that select the specific 256-byte block. * The second byte of the transmission contains the 8-bit address within that block. #### Write Operations * **Byte Write:** Writing a single byte to a specific address. * **Page Write:** Allows writing up to 16 bytes in a single write cycle, significantly improving performance for larger data sets. * **Write Control (WC):** A hardware pin that provides write protection. When held High, the memory becomes read-only. --- ### 3. Pinout Configuration (UFDFPN8) | Pin Number | Name | Function | | :--- | :--- | :--- | | 1-3 | E0, E1, E2 | Chip Enable (Address inputs) | | 4 | VSS | Ground | | 5 | SDA | Serial Data (Bi-directional) | | 6 | SCL | Serial Clock (Input) | | 7 | WC | Write Control (Active High) | | 8 | VCC | Supply Voltage | --- ### 4. Code Implementation Example (Arduino/C++) To interface with the M24C08 using the `Wire.h` library: ```cpp #include #define EEPROM_ADDR 0x50 // Base I2C address for M24C08 void writeEEPROM(int address, byte data) { Wire.beginTransmission(EEPROM_ADDR); Wire.write(address); // Address inside the EEPROM Wire.write(data); // Data to store Wire.endTransmission(); delay(5); // Required write cycle time } byte readEEPROM(int address) { byte rdata = 0xFF; Wire.beginTransmission(EEPROM_ADDR); Wire.write(address); Wire.endTransmission(); Wire.requestFrom(EEPROM_ADDR, 1); if (Wire.available()) rdata = Wire.read(); return rdata; } ``` ---
    ✨ Follow-up Questions
    • ⤷ How does the 'Write Control' (WC) pin behave if left floating?
    • ⤷ What is the difference between the M24C08-R and the M24C08-W variants?
    • ⤷ How do you address the four different 256-byte blocks over I2C?