M93C66-RDS3G/S
AI

The **M93C66-RDS3G/S** is a specific variant of the 4-Kbit serial Microwire EEPROM (Electrically Erasable Programmable Memory) manufactured by **STMicroelectronics**.
Below is a detailed breakdown of its electronic specifications and characteristics.
---
## 1. General Specifications
This device is designed for non-volatile data storage, meaning it retains information even when power is removed. It is commonly used in automotive and industrial applications.
| Feature | Specification |
| :--- | :--- |
| **Memory Size** | 4 Kbit (4096 bits) |
| **Organization** | Configurable: 256 x 16-bit or 512 x 8-bit |
| **Interface** | Microwire (Serial 3-Wire) |
| **Operating Voltage** | 1.8V to 5.5V |
| **Clock Frequency** | Up to 2 MHz |
| **Package Type** | TSSOP8 (Thin Shrink Small Outline Package) |
---
## 2. Part Number Breakdown (Decoding)
The suffix **RDS3G/S** provides specific information about the hardware revision and environmental standards:
* **M93C66**: Base part number (4-Kbit Microwire EEPROM).
* **-R**: Operating voltage range (1.8V to 5.5V).
* **D**: Device revision (Process technology identifier).
* **S**: Package type (TSSOP8, 169 mil width).
* **3**: Temperature range (-40°C to +125°C - Automotive Grade).
* **G**: ECOPACK2 (RoHS compliant, Halogen-free).
* **S**: Specific manufacturing flow or internal tracking code.
---
## 3. Pin Configuration (TSSOP8)
The device uses a standard 8-pin layout.
| Pin Number | Symbol | Description |
| :--- | :--- | :--- |
| 1 | **S** | Chip Select (Active High) |
| 2 | **C** | Serial Clock |
| 3 | **D** | Serial Data Input |
| 4 | **Q** | Serial Data Output |
| 5 | **Vss** | Ground |
| 6 | **ORG** | Organization Select (High = x16, Low = x8) |
| 7 | **DU** | Don't Use (Leave floating or connect to Vss) |
| 8 | **Vcc** | Supply Voltage |
---
## 4. Key Performance Features
* **Write Protection:** Software write protection for the entire memory array.
* **Durability:** Supports more than **4 million write cycles**.
* **Data Retention:** Guaranteed for more than **200 years**.
* **Self-Timed Programming:** The device handles the internal write cycle timing automatically (typically 5ms).
* **Sequential Read:** Allows reading the entire memory content in a single continuous stream.
---
## 5. Typical Application Circuit
To interface this with a microcontroller (MCU), use the following logic:
```cpp
// Example Logic Connection
MCU_GPIO_Output -> S (Chip Select)
MCU_SPI_SCK -> C (Serial Clock)
MCU_SPI_MOSI -> D (Data In)
MCU_SPI_MISO <- Q (Data Out)
VCC (3.3V/5V) -> Vcc
GND -> Vss
```
---
- ⤷
What is the difference between the x8 and x16 organization modes?
- ⤷ How does the Microwire protocol differ from standard SPI?
- ⤷ What are the specific automotive standards (like AEC-Q100) this part meets?