General Description:
The single channel DIN Rail Load Cell/Strain Gauge Bridge Isolating Repeater D1063S
acts as a transparent galvanic isolated interface installed between a weighing indicator
in Safe Area and a load cell (or group of load cells) in Hazardous Area;
it appears at the terminals of the indicator as a single load cell equivalent to the one
in the field. Provides a fully floating power supply voltage with remote sensing capability
to load cell located in Hazardous Area and repeats, while isolating, the mV signal output
to drive a load in Safe Area depending on the host system reference voltage.
Up to four 350 Ω load cells, or six 450 Ω load cells, or twelve 1000 Ω load cells can
connected in parallel.
Voltage reference (Safe Area side) is DIP switch configurable to select internal or
external (host system) supply. In addition a field wiring fault red LED indicates any
wire break in the Hazardous Area side.

Features:
Input from Zone 0 (Zone 20), Division 1,
installation in Zone 2, Division 2.
Strain Gauge Bridge Transparent Repeater.
to four 350 Ω load cells in parallel or
to six 450 Ω load cells in parallel or
to twelve 1000 Ω load cells in parallel.
Broken field wire fault detection.
High Accuracy.
Three port isolation, Input/Output/Supply.
EMC Compatibility to EN61000-6-2, EN61000-6-4.
field programmability by DIP switch.
ATEX, IECEx, FM & FM-C, Russian
Certifications.
Type Approval Certificate DNV and KR for
maritime applications.
High Reliability, SMD components.
Simplified installation using standard
DIN Rail and plug-in terminal blocks.
250 Vrms (Um) max. voltage allowed to the
instruments associated with the barrier.