Features
 AEC-Q100 qualified
 One full bridge for 6 A load (RON = 150 m)
 Two half bridges for 3 A load (RON = 300 m)
 Two half bridges for 0.5 A load
(RON = 1600 m)
 One high-side driver for 5 A load
(RON = 100 m)
 One configurable high-side driver for up to
1.5 A (RON = 500 m) or 0.35 A
(RON = 1600 m) load
 One configurable high-side driver for 0.7 A
(RON = 800 m) or 0.35 A (RON = 1600 m)
load
 Two high-side drivers for 0.5 A load
(RON = 1600 m)
 Programmable softstart function to drive loads
with higher inrush currents as current limitation
value
 Very low VS current consumption in standby
mode (IS < 6 μA typ; Tj  85 °C)
 Current monitor output for all high-side drivers
 Central two-stage charge pump
 Motor bridge driver with full Rdson down to 6 V
 Device contains temperature warning and
protection
 Open-load detection for all outputs
 Overcurrent protection for all outputs
 Separated half bridges for door lock motor
 Programmable PWM control of all outputs
 STM standard serial peripheral interface (STSPI
3.1)
 Control block for electrochromic element
 Electrochromic element can be negatively
discharged
 Prepared for additional fail-safe path for
H-bridge