[Description]
A multi purpose, anti-static matting for use on either workstation benches or as a flooring solution
in the workshops of advanced laboratories for microelectronic industries.

[Features]
• Made from anti-static (conductive) and static-dissipative materials with synthetic rubber
• Corrugated surface provides slip resistance and even footing
• Excellent abrasion resistance
• Easy to clean, sweep or hose off
• Resistant to cuts, tears, impact, ozone damage, fire and most chemicals
• 3mm thick double-layer structure
• Surface layer is a 1mm thick static-dissipative layer
• Available in blue and yellow surface with black textured bottom surface
• Studs sold separately (not included)
• Rivet & stud assembly, please referred to MPM: 067-1006
Grounding:
Sufficient ground cords should be used to reliably meet EN 61340-5-1 Table 3 less than 1 × 109 ohms for working surfaces.
Industry recommendation is that continuous runs of ESD matting should be grounded at 10ft intervals to allow proper charge
decay rates. Each individual ESD mat should be grounded with ground snaps located no further than five feet from either end.
Cleaning:
Please note that contact between the matting surface and any acid or alkali solvent is strictly prohibited (such as Benzene,
Alcohol etc), this will result in the antistatic performance wearing away. If cleaning is required, the matting may be wiped with a
cloth coated in a neutral solution (such as water).
Guidance on Use:
Matting materials have a tendency to shrink slightly when first unrolled. In applications where length is critical, allow the material
to relax for at least 4 hours before cutting to size. Matting should always be trimmed with a sharp knife or razor blade.
Cutting Tolerances:
Width ±6mm
Length ±6mm every linear foot of running material