EV2496M-R-00A, 2.5A, 36V STEP DOWN CONVERTER WITH USB CHARGING PORTS

PRELIMINARY SPECIFICATIONS SUBJECT TO CHANGE

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV2496M-R-00A Rev.1.1

www.MonolithicPower.com

6

3/15/2017

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

Preliminary Specifications Subject to Change

© 2017 MPS. All Rights Reserved.

QUICK START GUIDE

1. Connect the positive and negative terminals of the load to the USB and GND pins, respectively.

2. Preset the power supply output between 7V and 36V, and then turn off the power supply.

3. Connect the positive and negative terminals of the power supply output to the VIN and GND

pins, respectively.

4. Turn the power supply on. The board will automatically start up.

5. To use the Enable function, apply a digital input to the EN pin. Drive EN higher than 2V to turn

on the regulator or less than 1V to turn it off.