EV3356DG-00A-INTEGRATED PHOTO FLASH CHARGER, IGBT DRIVER EV BOARD

NOTICE:

The information in this document is subject to change without notice. Please contact MPS for current specifications.

Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS

products into any application. MPS will not assume any legal responsibility for any said applications.

EV3356DG-00A Rev. 1.0

www.MonolithicPower.com

6

9/23/2011

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2011 MPS. All Rights Reserved.

QUICK START GUIDE

1. Solder Q1, trigger coil-T2 and Xenon Flash tube to the board if they are not populated.

2. Turn off the power supply.

3. Attach the positive terminal of the power supply (3V - 6V) to the VIN.

4. Attach the negative terminal of the power supply to GND pin.

5. Turn on the power supply.

6. Press “FLASH”-SW1 once to trigger the flash sequencing. First, the microcontroller will enable

charge for certain time and then trigger the IGBT to light up the flash tube.

7. “ENABLE”-SW2 serves only as a toggle SW to start/stop the charge, no flash will be triggered.