M34F04 datasheet(12/20 Pages) STMICROELECTRONICS

Part #	M34F04

Description	4Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Half of Memory

PDF	20 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

12 / 20 page

M34F04

12/20

master does acknowledge the data byte output,

and sends additional clock pulses so that the de-

vice continues to output the next byte in sequence.

To terminate the stream of bytes, the bus master

must not acknowledge the last byte, and must

generate a Stop condition, as shown in Figure 9.

The output data comes from consecutive address-

es, with the internal address counter automatically

incremented after each byte output. After the last

memory address, the address counter ‘rolls-over’,

and the device continues to output data from

memory address 00h.

Acknowledge in Read Mode

For all Read commands, the device waits, after

each byte read, for an acknowledgment during the

9th bit time. If the bus master does not drive Serial

Data (SDA) Low during this time, the device termi-

nates the data transfer and switches to its Stand-

by mode.

INITIAL DELIVERY STATE

The device is delivered with the memory array

erased: all bits are set to 1 (each byte contains

FFh).

M34F04 Datasheet(PDF) 12 Page - STMicroelectronics