LTC6101ACMS8 datasheet(13/20 Pages) LINER

13 / 20 page

LTC6101/LTC6101HV

6101fa

APPLICATIO S I FOR ATIO

be taken to limit the maximum output current by proper

choice of sense resistor and, if input fault conditions exist,

external clamps.

Output Filtering

The output voltage, VOUT, is simply IOUT• ZOUT. This makes

filtering straightforward. Any circuit may be used which

generates the required ZOUT to get the desired filter

response. For example, a capacitor in parallel with ROUT

will give a low pass response. This will reduce unwanted

noise from the output, and may also be useful as a charge

reservoir to keep the output steady while driving a switch-

ing circuit such as a mux or ADC. This output capacitor in

parallel with an output resistor will create a pole in the

output response at:

OUT

–

••

•

Useful Equations

Input Voltage: V

Voltage Gain:

Current Gain:

Transconductance:

Transimpedance:

SENSE

OUT

SENSE

OUT

SENSE

OUT

SENSE

OUT

SENSE

OUT

SENSE

OUT

•

Input Common Mode Range

The inputs of the LTC6101 can function from 1.5V below

the positive supply to 0.5V above it. Not only does this

Figure 5. V+ Powered Separately from

Load Supply (VBATT)

Figure 6. LTC6101 Supply Current

Monitored with Load

LTC6101

ROUT

VOUT

6101 F05

RIN

LOAD

V+

RSENSE

VBATTERY

LTC6101

ROUT

VOUT

6101 F06

RIN

LOAD

V+

RSENSE

allow a wide VSENSE range, it also allows the input refer-

ence to be separate from the positive supply (Figure 5).

Note that the difference between VBATT and V+ must be no

more than the common mode range listed in the Electrical

Characteristics table. If the maximum VSENSE is less than

500mV, the LTC6101 may monitor its own supply current,

as well as that of the load (Figure 6).

LTC6101ACMS8 Datasheet(PDF) 13 Page - Linear Technology

LTC6101ACMS8 Datasheet(HTML) 13 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Datasheet Download

Link URL