DSP56857 datasheet(398/662 Pages) FREESCALE

398 / 662 page

5685X Digital Signal Controller User Manual, Rev. 4

14-12

Freescale Semiconductor

14.6.5 Time-of-Day Seconds Alarm Register (TODSAL)

Figure 14-6. TOD Seconds Alarm Register (TODSAL)

See Programmer’s Sheet on Appendix page B - 98

14.6.5.1 Reserved—Bits 15–6

These bits are reserved or not implemented. They cannot be read nor modified by writing.

14.6.5.2 Time-of-Day Seconds Alarm (TODSAL)—Bits 5–0

When the value contained in this register matches the value of the seconds counter, the seconds

alarm is asserted if the Seconds Alarm Enable (TODSA) bit and Alarm Interrupt Enable

(TODAEN) bits are set and all other enabled alarm registers also match.

14.6.6 Time-of-Day Minutes Register (TODMIN)

14.6.6.1 Reserved—Bits 15–6

These bits are reserved or not implemented. They cannot be read nor modified by writing.

14.6.6.2 Time-of-Day Minutes (TODMIN)—Bits 5–0

When TODEN is set, this register is continuously updated to contain the current minutes counter

value. The value of the counter can be read through the minutes register, but it cannot be

modified. When TODEN is cleared, TOD counting is disabled. This register can then be read or

written. When TODEN is set to one again, the counting resumes from the current register value.

Base + $3

Read

TODSAL

Write

Reset

000

Base + $4

Read

TODMIN

Write

Reset

00000000000000

Figure 14-7. TOD Minutes Register (TODMIN)

See Programmer’s Sheet on Appendix page B - 99

DSP56857 Datasheet(PDF) 398 Page - Freescale Semiconductor, Inc