DS9034PCX datasheet(5/10 Pages) ARTSCHIP

5 / 10 page

DS1647/DS1647P

Nonvolatile Timekeeping RAM

www.artschip.com

Table 2. Register Map-BANK1

DATA

ADDRESS

FUNCTION

7FFFF

Year

00-99

7FFFE

Month

01-12

7FFFD

Date

01-31

7FFFC

Day

01-07

7FFFB

Hour

00-23

7FFFA

Minutes

00-59

7FFF9

Seconds

00-59

7FFF8

Control

=STOP BIT

R=READ BIT

FT=FREQUENCY TEST

W=WRITE BIT

X=UNUSED

Note: All indicated “X” bits are not dedicated to any particular function and can be used ad normal RAM bits.

RETRIEVING DATA FROM RAM OR CLOCK

The DS1647 is in the read mode whenever

(write enable) is high;

(chip enable) is low. The device architecture allows

ripple-through access to any of the address locations in the NV SRAM. Valid data will be available at the DQ pins within tAA after

the last address input is stable, providing that the

and

access times and states are satisfied. If

and

access

times are not met, valid data will be available at the latter of chip-enable access (tCEA) or at output enable access time (tOEA). The

state of the data input/output pins (DQ) is controlled by

and

. If the outputs are activated before tAA, the data lines are

driven to an intermediate state until tAA. If the address inputs are changed while

and

remain valid, output data will

remain valid for output data hold time (tOH) but will then go indeterminate until the next address access.

WRITING DATA TO RAM OR CLOCK

The DS1647 is in the write mode whenever

and

are in their active state. The start of a write is referenced to the latter

occurring high to low transition of

and

. The addresses must be held valid throughout the cycle.

must return

inactive for a minimum of tWR prior to the initiation of another read or write cycle. Data in must be valid tDS prior to the end of write

and remain valid for tDH afterward. In a typical application, the

signal will be high during a write cycle. However,

can be

active provided that care is taken with the data bus to avoid bus contention.

is low prior to

transitioning low the data

bus can become active with read data defined by the address inputs. A low transition on

will then disable the outputs tWEZ after

goes active.

DATA-RETENTION MODE

When Vcc is within nominal limits (Vcc>4.5V) the DS1647 can be accessed as described above with read or write cycles.

However, when Vcc is below the power-fail point VPF (point at which write protection occurs) the internal clock registers and RAM

are blocked from all access. This is accomplished internally by inhibiting access via the

signal. At this time the power-fail

output signal (

) will be driven active low and will remain active until Vcc returns to nominal levels. When Vcc falls below the

level of the internal battery supply, power input is switched from the Vcc pin to the internal battery and clock activity, RAM, and

clock data are maintained from the battery until Vcc is returned to nominal level.

DS9034PCX Datasheet(PDF) 5 Page - ARTSCHIP ELECTRONICS CO.,LMITED.

DS9034PCX Datasheet(HTML) 5 Page - ARTSCHIP ELECTRONICS CO.,LMITED.

Html Pages

1 2 3 4 5 6 7 8 9 10

Datasheet Download

Link URL