DSC1103 datasheet(2/26 Pages) MICROCHIP

2 / 26 page

DSC1103/23

DS20005745B-page 2

 2017-2018 Microchip Technology Inc.

1.0

ELECTRICAL CHARACTERISTICS

Absolute Maximum Ratings †

Supply Voltage .......................................................................................................................................... –0.3V to +4.0V

Input Voltage .......................................................................................................................................–0.3V to VDD+0.3V

ESD Protection (HBM) ...............................................................................................................................................4 kV

ESD Protection (MM) ................................................................................................................................................400V

ESD Protection (CDM) ............................................................................................................................................1.5 kV

† Notice: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.

This is a stress rating only and functional operation of the device at those or any other conditions above those indicated

in the operational sections of this specification is not intended. Exposure to maximum rating conditions for extended

periods may affect device reliability.

ELECTRICAL CHARACTERISTICS

Specifications: VDD = 3.3V; TA = +25°C unless otherwise specified.

Parameters

Sym.

Min.

Typ.

Max.

Units

Conditions

Supply Voltage (Note 1)VDD

2.25

—

3.63

—

Supply Current

IDD

—

0.095

DSC1103, EN pin low; all

outputs disabled.

—20

DSC1123, EN pin low; all

outputs disabled.

Frequency Stability

∆f

——

±10

ppm

Includes frequency

variations due to initial

tolerance, temp., and power

supply voltage.

——

±20

——

±25

——

±50

Aging - First Year

∆fY1

—

±5

ppm

One year at +25°C

Aging - After First Year

∆fY2+

—

<±1

ppm/yr

Year two and beyond at

+25°C

Start-up Time (Note 2)tSU

—

T = +25°C

Input Logic Levels

VIH

0.75 x VDD

——

Input logic high

VIL

—

0.25 x VDD

Input logic low

Output Disable Time (Note 3)tDA

——

—

Output Enable Time

tEN

—

DSC1103

—

DSC1123

Enable Pull-Up Resistor

(Note 4)

RPU

—40

—

kΩ

Pull-up resistor exist.

LVDS Outputs

Supply Current

IDD

—

Output enabled, RL = 100Ω

Output Offset Voltage

VOS

1.125

—

1.4

R = 100Ω Differential

Delta Offset Voltage

∆VOS

——

—

Peak-to-Peak Output Swing

VPP

—

350

—

Single-Ended

Note 1: VDD pin should be filtered with a 0.1 µF capacitor.

2: tSU is time to 100 ppm stable output frequency after VDD is applied and outputs are enabled.

3: See the Output Waveform section and the Test Circuit for more information.

4: Output is enabled if pad is floated or not connected.

DSC1103 Datasheet(PDF) 2 Page - Microchip Technology

DSC1103 Datasheet(HTML) 2 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Datasheet Download

Link URL