MCP23008-ESLASHSS datasheet(15/40 Pages) MICROCHIP

15 / 40 page

DS21919B-page 15

MCP23008/MCP23S08

1.6.8

INTERRUPT FLAG (INTF)

The INTF register reflects the interrupt condition on the

port pins of any pin that is enabled for interrupts via the

GPINTEN register. A ‘set’ bit indicates that the

associated pin caused the interrupt.

This register is ‘read-only’. Writes to this register will be

ignored.

INTF – INTERRUPT FLAG REGISTER (ADDR 0x07)

Note:

INTF will always reflect the pin(s) that

have an interrupt condition. For example,

one pin causes an interrupt to occur and is

captured in INTCAP and INF. If, before

clearing the interrupt, another pin changes

which would normally cause an interrupt, it

will be reflected in INTF, but not INTCAP.

R-0

INT7

INT6

INT5

INT4

INT3

INT2

INT1

INT0

bit 7

bit 0

bit 7-0

INT7:INT0: These bits reflect the interrupt condition on the port. Will reflect the change only if

interrupts are enabled (GPINTEN) <7:0>.

= Pin caused interrupt.

= Interrupt not pending.

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as ‘0’

- n = Value at POR

‘1’ = Bit is set

‘0’ = Bit is cleared

x = Bit is unknown

MCP23008-E/SS Datasheet(PDF) 15 Page - Microchip Technology

MCP23008-E/SS Datasheet(HTML) 15 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Datasheet Download

Link URL