ICM108B 1.3 million pixel CMOS sensor
Data Sheet V 1.1 November, 2002
©2000, 2001, 2002 IC Media Corporation & IC Media Technology Corp.
11/22/2002
page 7
COMPANY CONFIDENTIAL
2.5 Output Format
During normal operation, the output format is 10-bit raw data that ranges from 0 to 1023. It may be used
for off-chip color processing or compression. A typical configuration is to connect ICM-108B to a USB1,
a USB2, or a 1394/Compression combo chip. At 30 fps, the PCLK and main clock are both operating at 48
MHz.
In addition to the data pins, the chip also output VSYNC, HSYNC, and PCLK. The length and polarity of
VSYNC and HSYNC can be adjusted through registers. The line and frame timing can be adjusted through
registers AD_WIDTH and AD_HEIGHT.
2.6 SIF Interface
Register programming is through SIF interface (SCL and SDA pins). The default 7-bit SIF device address
is 0x20, meanwhile the last bit can be configured by the SIF ID pin. ICM-108B can operate in either SIF
master mode or slave mode right after power up, depending on the pull-up or pull-down of the MSSEL pin.
When MSSEL is pulled low during power-up, ICM-108B’s SIF interface is operated as an SIF slave
device, waiting to be controlled by an external SIF master such as a microprocessor. When MSSEL is
pulled high during power-up, the SIF interface is first acting as an SIF master device trying to read from an
external SIF EEPROM. After that, it will fall back to behave like an SIF slave.
New Zealand ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
