Technical data sheet

AFB24-IP

www.belimo.us

AFB24-IP • en-us • 2020-09-01 • Subject to change

2 / 4

Agency Listing

cULus acc. to UL60730-1A/-2-14, CAN/CSA

E60730-1:02, CE acc. to 2014/30/EU and 2014/35/

EU; Listed to UL 2043 - suitable for use in air

plenums per Section 300.22(c) of the NEC and

Section 602.2 of the IMC

Quality Standard

ISO 9001

Mode of operation

Type 1

Rated impulse voltage supply / control

0.8 kV

Ambient temperature

-22...122°F [-30...50°C]

Storage temperature

-40...176°F [-40...80°C]

Ambient humidity

max. 95% r.H., non-condensing

Servicing

maintenance-free

Weight Weight

5.3 lb [2.4 kg]

Materials Housing material

Galvanized steel and plastic housing

Safety notes

• The device must not be used outside the specified field of application, especially not in aircraft or in any

other airborne means of transport.

• Outdoor application: only possible in case that no (sea) water, snow, ice, insolation or aggressive gases

interfere directly with the actuator and that is ensured that the ambient conditions remain at any time

within the thresholds according to the data sheet.

• Only authorised specialists may carry out installation. All applicable legal or institutional installation

regulations must be complied during installation.

• The device may only be opened at the manufacturer's site. It does not contain any parts that can be

replaced or repaired by the user.

• Cables must not be removed from the device.

• To calculate the torque required, the specifications supplied by the damper manufacturers concerning

the cross-section, the design, the installation site and the ventilation conditions must be observed.

• The device contains electrical and electronic components and must not be disposed of as household

refuse. All locally valid regulations and requirements must be observed.

Product features

The actuator is controlled via the Cloud, BACnet IP or Modbus TCP and drives to the position defined by

the control signal. Various data points can be written and read via the same interfaces.

Hybrid mode:

The actuator receives its analog control signal from the higher level controller and drives to the position

defined. Using the Cloud, BACnet IP or Modbus TCP, various data points can be read and with the

exception of the control signal written.

Connection option for two sensors (passive sensor, active sensor or switching contact). The actuator

serves as an analogue/digital converter for the transmission of the sensor signal to the higher level

system.

The configuration can be carried out through the integrated web server (RJ45 connection to the web

browser), by communicative means or via the Cloud.

Additional information regarding the integrated web server can be found in the separate documentation.

"Peer to Peer" connection

http://belimo.local:8080

The Notebook must be set to "DHCP".

Make sure that only one network connection is

active.

Standard IP address:

http://192.168.0.10:8080

Static IP address

Password (read-only):

User name: «guest»

Password: «guest»

Mode of operation

Converter for sensors

Communication