AT25SL128A datasheet(39/75 Pages) DIALOG

Part #	AT25SL128A

Description	128-Mbit, 1.7V Minimum SPI Serial Flash Memory with Dual I/O, Quad I/O and QPI Support

PDF	75 Pages

Scroll/Zoom	100%

Manufacturer	DIALOG [Dialog Semiconductor]

Direct Link	http://www.dialog-semiconductor.com/

Logo

39 / 75 page

AT25SL128A

DS-AT25SL128A–109K–02/2019

Figure 7-36. Erase / Program Resume instruction (QPI Mode)

7.23

Deep Power Down (B9h)

Executing the Deep Power Down instruction is the best way to put the device in the lowest power consumption. The

Deep Power Down instruction reduces the standby current (from ICC1 to ICC2, as specified in AC characteristics). The

instruction is entered by driving the CS pin low with following the instruction code “B9h”. (Please refer to Figure 7-37 and

Figure 7-38).

The CS pin must go high exactly at the byte boundary (the latest eighth bit of instruction code been latched-in);

otherwise, the Deep Power Down instruction is not executed. After CS goes high, it requires a delay of t

DP and the Deep

Power Down mode is entered. While in the Release Deep Power Down / Device ID instruction, which restores the device

to normal operation, will be recognized. All other instructions are ignored including the Read Status Register instruction,

which is always available during normal operation. Deep Power Down Mode automatically stops at Power-Down, and the

device always Power-up in the Standby Mode.

Figure 7-37. Deep Power Down Instruction (SPI Mode)

AT25SL128A Datasheet(PDF) 39 Page - Dialog Semiconductor