MODEL: R3-NE1

R3-NE1 SPECIFICATIONS

ES-8361 Rev.24 Page 6/8

https://www.m-system.co.jp/

■ TEMPERATURE DATA (16-bit data, models: R3-RS4, TS4, US4, etc.)

0

15

16-bit binary data.

With °C temperature unit, raw data is multiplied by 10. For example, 25.5°C is converted into 255.

With °F temperature unit, the integer section of raw data is directly converted into the data.

For example, 135.4°F is converted into 135.

Minus temperature is converted into negative values, represented in 2’s complements.

■ ANALOG DATA (16-bit data, models: R3-CT4A, CT4B, etc.)

0

15

16-bit binary data.

Integer obtained by multiplying unit value (A) by 100.

In case of CLSE-R5, integer obtained by multiplying unit value (A) by 1000.

■ ACCUMULATED COUNT DATA (32-bit data, models: R3-PA2, PA4A, WT1, WT4, etc.)

32-bit binary data is used for accumulated counts and encoder positions.

Lower 16 bits are allocated from the lowest address to higher ones, higher 16 bits in turn.

32-bit data cannot be accessed using oating addresses.

0

15

+0

Lower 16 bits

0

15

+1

Higher 16 bits

■ BCD DATA (32-bit data, models: R3-BA32A, BC32A, etc.)

32-bit binary data is used for BCD.

Lower 16 bits are allocated from the lowest address to higher ones, higher 16 bits in turn.

32-bit data cannot be accessed using oating addresses.

0

15

+0

Lower 16 bits

0

15

+1

Higher 16 bits

■ 16-POINT DISCRETE DATA (models: R3-DA16, DC16, etc.)

0

15

Input 1 (Output 1)

Input 2 (Output 2)

Input 3 (Output 3)

:

:

Input 16 (Output 16)

0 : OFF

1 : ON