M25P128 datasheet(17/41 Pages) STMICROELECTRONICS

17 / 41 page

M25P128

Instructions

Rev. 1

17/41

6.1

Write Enable (WREN)

The Write Enable (WREN) instruction (Figure 8) sets the Write Enable Latch (WEL) bit.

The Write Enable Latch (WEL) bit must be set prior to every Page Program (PP), Sector

Erase (SE), Bulk Erase (BE) and Write Status Register (WRSR) instruction.

The Write Enable (WREN) instruction is entered by driving Chip Select (S) Low, sending the

instruction code, and then driving Chip Select (S) High.

Figure 8.

Write Enable (WREN) Instruction Sequence

6.2

Write Disable (WRDI)

The Write Disable (WRDI) instruction (Figure 9) resets the Write Enable Latch (WEL) bit.

The Write Disable (WRDI) instruction is entered by driving Chip Select (S) Low, sending the

instruction code, and then driving Chip Select (S) High.

The Write Enable Latch (WEL) bit is reset under the following conditions:

●

Power-up

●

Write Disable (WRDI) instruction completion

●

Write Status Register (WRSR) instruction completion

●

Page Program (PP) instruction completion

●

Sector Erase (SE) instruction completion

●

Bulk Erase (BE) instruction completion

Figure 9.

Write Disable (WRDI) Instruction Sequence

AI02281E

34567

High Impedance

Instruction

AI03750D

34567

High Impedance

Instruction

M25P128 Datasheet(PDF) 17 Page - STMicroelectronics