USB2640I datasheet(21/59 Pages) MICROCHIP

21 / 59 page

 2015-2021 Microchip Technology Inc.

DS00001948C-page 21

USB2640i/USB2641i

6.4

ROM BOOT Sequence

After power-on reset, the internal firmware checks for an external SPI flash device that contains a valid signature of

"2DFU" (device firmware upgrade) beginning at address 0xFFFA. If a valid signature is found, then the external ROM

is enabled and code execution begins at address 0x0000 in the external SPI device. Otherwise, code execution contin-

ues from the internal ROM.

If there is no SPI ROM detected, the internal firmware then checks for the presence of an I2C ROM. The firmware looks

for the signature ‘ATA2’ at the offset of 0xFC-0xFF in the I2C ROM. The firmware reads in the I2C ROM to configure the

hardware and software internally. Please refer to section Section 7.3.2, "EEPROM Data Descriptor," on page 23 for the

details of the configuration options.

The SPI ROM required for the USB2640i/USB2641i must be 1 Mbit and support either 30 MHz or 60 MHz. The fre-

quency used is set using the SPI_SPD_SEL. For 30 MHz operation, this pin must be pulled to ground through a 100 k



resistor. For 60 MHz operation, this pin must pulled up through a 100 k

 resistor. SPI_SPD_SEL: This pin is used to

choose the speed of the SPI interface. During nRESET assertion, this pin will be tri-stated with the weak pull-down resis-

tor enabled. When nRESET is negated, the value on the pin will be internally latched, and the pin will revert to SPI_DO

functionality, the internal pull-down will be disabled.

The firmware can determine the speed of operation on the SPI port by checking the SPI_SPEED in the SPI_CTL register

(0x2400 - RESET = 0x02). Both 1- and 2-bit SPI operation is supported. For optimum throughput, a 2-bit SPI ROM is

recommended. Both mode 0 and mode 3 SPI ROMS are also supported.

FIGURE 6-4:

USB2640I/USB2641I SPI ROM CONNECTION

FIGURE 6-5:

USB2640I/USB2641I I2C CONNECTION

SPI_CE_N

SPI_CLK / SCL

SPI_DI

USB2640i/

USB2641i

SPI_DO / SDA / SPI_SPD_SEL

SPI ROM

CE#

CLK

I2C ROM

SCL

SDA

3.3V

10K

USB2640i/

USB2641i

USB2640I Datasheet(PDF) 21 Page - Microchip Technology

USB2640I Datasheet(HTML) 21 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59

Datasheet Download

Link URL