MDEV-868-PRC datasheet(53/55 Pages) LINX

53 / 55 page

–

100

101

Regulatory Standards Tested

• Operating Frequency - EN 300 220-1 v3.1.1 (2017-02) Section 5.1.2

• Unwanted Emissions in the Spurious Domain - EN 300 220-1 v3.1.1

(2017-02) Section 5.9.2

• Effective Radiated Power - EN 300 220-1 v3.1.1 (2017-02) Section

5.2.2

• Occupied Bandwidth - EN 300 220-1 v3.1.1 (2017-02) Section 5.6.2

• TX out of band Emissions - EN 300 220-1 v3.1.1 (2017-02) Section

5.8.2

• Transient Power - EN 300 220-1 v3.1.1 (2017-02) Section 5.10.2

• TX Behavior under Low Voltage Conditions - EN 300 220-1 v3.1.1

(2017-02) Section 5.12.2

• RX Sensitivity - EN 300 220-1 v3.1.1 (2017-02) Section 5.14.2

• Blocking - EN 300 220-1 v3.1.1 (2017-02) Section 5.14.2

• Clear Channel Assessment Method - EN 300 220-1 v3.1.1 (2017-02)

Section 5.21.2

• Polite Spectrum Access Timing Parameters - EN 300 220-1 v3.1.1

(2017-02) Section 5.21.3

• Adaptive Frequency Agility - EN 300 220-1 v3.1.1 (2017-02) Section

5.21.4

• Indirect ESD, ±2.0 kV and ±4.0 kV (HCP and VCP) - EN 301 489-3

v1.6.1

• Radiated RF EM Field Test - EN301 489-3 v1.6.1

OEM Labeling Requirements

The CE mark must be placed on the OEM product in a visible location. The

CE mark shall consist of the initials CE as shown in Figure 106.

• If the CE marking is reduced or enlarged, the proportions given in the

above graduated drawing must be adhered to.

• The CE marking must have a height of at least 5 mm except where this

is not possible on account of the nature of the product.

• The CE marking must be affixed visibly, legibly, and indelibly.

Figure 106: The CE Mark

MDEV-868-PRC Datasheet(PDF) 53 Page - Linx Technologies