PI3CH480

www.diodes.com

November 2018

Document Number DS40329 Rev 3-2

2

© Diodes Incorporated

PI3CH480

Pin Description

Pin No of

TSSOP

QSOP

Pin No of

UQFN3x3-

16

Pin Name

Description

1

15

S

Select Inputs

2, 3, 5, 6,

11,10,14,13

16,1,3,4,

9,8,12,11

Data Inputs

4, 7, 9, 12

2,5,7,10

Data Outputs

8

6

GND

Ground

15

13

1111111

EN

Enable

16

14

Power

—

Center Pad

GND

—

Maximum Ratings

StorageTemperature....................................................................................-65°C to +150°C

Supply Voltage to Ground Potential............................................................-0.5V to + 4.6V

DC Input Voltage ............................................................................................-0.5V to + 6.0V

DC Output Current

Power Dissipation..............................................................................................................0.5W

DC Electrical Characteristics

Symbol

Description

Test Conditions

(1)

Min

Typ

(2)

Max

Unit

Control Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

—

—

V

Control Input LOW Voltage

Guaranteed Logic LOW Level

-0.5

—

0.8

V

Clamp Diode Voltage

—

-1.3

-1.8

V

Input HIGH Current

—

—

±1

μA

Input Low Current

—

—

±1

μA

High-Impedance Current

(3)

0 ≤ Y, In ≤ V

CC

—

—

±1

μA

Switch On-Resistance

(4)

—

4

6

Ω

—

5

8

Notes:

1. For maximum or minimum conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between Y and In pin at indicated current through the switch. ON resistance is determined by the lower of the

voltages on the two (Y, In) pins.

Note:

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the device.

This is a stress rating only and functional operation of the

device at these or any other conditions above those

indicated in the operational sections of this specification

is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect reliability.