| Electronic Components Datasheet Search |
|
AIS2DW12TR Datasheet(PDF) 20 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
AIS2DW12TR Datasheet(HTML) 20 Page - STMicroelectronics |
|
20 / 60 page ![]() Terminology and functionality AIS2DW12 20/60 DocID031240 Rev 4 All ODRs in the range from 0 to up to 100 Hz are supported due to the INT2 clock input. A DRDY signal or FIFO flags are available on the INT1 pin. Power consumption is the same as that of standard power modes for the same ODR. Figure 5. Single data conversion on demand functionality At the end of turn-on time T_on, the DRDY interrupt is activated, output data are available to be read and the device goes into power-down. T_on values depend on the power mode as follows: T_on (typ.) = 1.20 ms for Power Mode 1 1.70 ms for Power Mode 2 2.30 ms for Power Mode 3 3.55 ms for Power Mode 4 3.2.3 Self-test The self-test allows checking the sensor functionality without moving it. The self-test function is off when the self-test bits (ST) are programmed to ‘00’. When the self-test bits are changed, an actuation force is applied to the sensor, simulating a definite input acceleration. In this case the sensor outputs will exhibit a change in their DC levels which are related to the selected full scale through the device sensitivity. When the self-test is activated, the device output level is given by the algebraic sum of the signals produced by the acceleration acting on the sensor and by the electrostatic test-force. If the output signals change within the amplitude specified in Table 4, then the sensor is working properly and the parameters of the interface chip are within the defined specifications. 3.2.4 Activity/Inactivity, stationary/motion detection functions The activity/inactivity function recognizes the device’s sleep state and allows reducing system power consumption. When the activity/inactivity function is activated by setting the SLEEP_ON bit in WAKE_UP_THS (34h), the AIS2DW12 automatically goes to 12.5 Hz ODR in the mode previously selected by the PW_MODE[1:0] bits in CTRL1 (20h) if the sleep state condition is detected and wakes up as soon as the interrupt event has been detected, increasing the output data rate and bandwidth. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |