FDA903U datasheet(43/80 Pages) STMICROELECTRONICS

Part #	FDA903U

Description	1 x 45 W class D digital input automotive power amplifier with ILoad current monitoring, wide voltage operation range for car audio and telematic

PDF	80 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

43 / 80 page

DS12498 Rev 2

43/80

FDA903U

Diagnostic

Moreover, if the high-pass filter function is enabled through IB3[2], the input offset is

eliminated, guaranteeing a complete robustness in case of any malfunction coming from the

audio signal source.

10.6

Output voltage offset detector

The output voltage offset detector aim is to detect a voltage offset on the output.

For this purpose, an internal circuit detects when the voltage value on FBP pin or on FBM

pin exceeds 1V difference with respect to Vcc/2 value, generating a fault condition. If the

fault condition persists for 90ms consecutively, the circuits set the flag on I2C bit DB0[3]. As

soon as the fault condition is removed, both the flag DB0[3] and the 90ms counter are reset.

The implemented logic avoids false detections in case of very low signal frequency.

The feature operation is showed in Figure 58:

Figure 58. Output voltage offset detector operation

When enabled, the feature is active both in MUTE and in PLAY states.

Please note that the Output Voltage Offset Detector must not be enabled when FBP and

FBM pins are shorted with OUTP and OUTM pins the full-swing PWM outputs don't allow

the fault condition persisting for more than 90ms even in case of offset. A valid and robust

alternative is provided by the Output Current Offset Detector.

The offset detector output is provided in two forms:



Enables the pull down on CDDiag pin, if IB4[7]='1'



Sets the flag DB0[3]='1'

FDA903U Datasheet(PDF) 43 Page - STMicroelectronics