24232103 datasheet(17/109 Pages) TOSHIBA

17 / 109 page

– 17 –

PROGRAMMING CHANNEL MEMORY

The channel memory is the list of TV channel numbers your TV will stop on when you press the CHANNEL s or t button.

First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area automatically.

If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels.

Note: If you utilize both ANT-1 and ANT-2 terminals for some model, perform programming channels for each input source.

TV/CABLE function

1 Press MENU, then press S or T until the SET UP menu

appears.

2 Press t (or s) until “TV/CABLE” is highlighted.

3 Press : or ; to highlight either “TV” or “CABLE”, whichever

you use.

CH PROGRAM function

1 Select “CH PROGRAM” following steps 1 and 2 above.

2 Press : or ; to start channel programming.

The TV will automatically cycle through all the TV or CABLE

channels selected by the TV/CABLE function, and store

active channels in the channel memory.

3 When channel programming is complete, you will see the

message to the right.

4 Press CHANNEL s or t to make sure the channel pro-

gramming has been done properly.

ADD/ERASE function

After performing the CH PROGRAM function, you can add

or erase specific channels.

1 Select the channel you want to erase using the CHANNEL

s or t button, or select the channel you want to add using

the Channel Number buttons.

2 Press MENU, then press S or T until the SET UP menu

appears.

3 Press t (or s) until “ADD/ERASE” is highlighted.

4 Press S or T :

To erase the channel

Press the button until “Erase” is highlighted.

To add the channel

Press the button until “Add” is highlighted.

5 Repeat steps 1 to 4 for other channels.

You have now completed the channel programming.

Note: The CHANNEL t/s buttons on the TV function as

the t/s buttons while a menu is on the screen.

∗ Please refer to owner's manual in detail.

24232103 Datasheet(PDF) 17 Page - Toshiba Semiconductor