H7CC-R11D datasheet(37/66 Pages) OMRON

37 / 66 page

H7CC-A

tachometer

Operation in Run Mode

Tachometer Operation

＊4

*4. Peak/bottom hold enabled

*1. Not displayed for the 2-input mode.

*2. Measurement value 1 for the 2-input input mode.

*3. Measurement value 2 for the 2-input input mode.

Measurement value 1

Comparison value 1

Measurement value 2

Comparison value 2

Measurement value

Bottom hold value

Peak hold value

Bottom hold value 1

Peak hold value 1

Bottom hold value 2

Peak hold value 2

• Measurement value

Displays the currently measured value.

• Comparison value 1/Comparison value 2

Set comparison value 1 and comparison value 2.

The measurement value is compared to

comparison value 1 and comparison value 2 and

output is made according to the selected output

mode.

Displayed when the input mode is not 2 inputs.

Displayed for the 2-input input mode.

• Peak/bottom hold value

The peak (maximum) and bottom (minimum)

values are displayed after counting starts.

• Peak/bottom hold value 1 and 2

Peaks (maximums) 1 and 2 and bottoms

(minimums) 1 and 2 are displayed after counting

starts.

• Set each digit using the individual UP1 to UP6 Keys (DW1 to DW6 Keys).

* Use UP1+UP3 to move up and

DW1+DW3 to move down

* Use UP1+UP3 to move up and

DW1+DW3 to move down

* Use UP1+UP3 to move up and

DW1+DW3 to move down

Note: The hold values will be initialized when

reset operation is performed or reset 1

input is turned OFF while peak/bottom

hold values 1 and 2 are being displayed.

(The reset 2 input operates in the same

way if the input mode is set to 2-input

mode.)

H7CC-R11D Datasheet(PDF) 37 Page - Omron Electronics LLC

H7CC-R11D Datasheet(HTML) 37 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66

Datasheet Download

Link URL