XRT75R06IB datasheet(13/63 Pages) EXAR

13 / 63 page

áç

XRT75R06

SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR

REV. 1.0.0

D12

R11

C11

RLOL_0

RLOL_1

RLOL_2

RLOL_3

RLOL_4

RLOL_5

Receive Loss of Lock - Channel 0:

Receive Loss of Lock - Channel 1:

Receive Loss of Lock - Channel 2:

Receive Loss of Lock - Channel 3:

Receive Loss of Lock - Channel 4:

Receive Loss of Lock - Channel 5:

This output pin toggles "High" if a Loss of Lock Condition is detected. LOL

(Loss of Lock) condition occurs if the recovered clock frequency deviates from

the Reference Clock frequency (available at either E3CLK or DS3CLK or STS-

1CLK input pins) by more than 0.5%.

L16

RXA

****

External Resistor of 3.01K

Ω ± 1%.

Should be connected between RxA and RxB for internal bias.

K16

RXB

****

External Resistor of 3.01K

Ω ±1%.

Should be connected between RxA and RxB for internal bias.

P12

ICT

In-Circuit Test Input:

Setting this pin "Low" causes all digital and analog outputs to go into a high-

impedance state to allow for in-circuit testing. For normal operation, tie this pin

"High".

NOTE: This pin is internally pulled up.

R12

TEST

****

Factory Test Pin

NOTE: This pin must be connected to GND for normal operation.

MICROPROCESSOR INTERFACE

LEAD #

SIGNAL NAME

TYPE

DESCRIPTION

Chip Select

Tie this “Low” to enable the communication with the Microprocessor Interface.

PCLK

Processor Clock Input

To operate the Microprocessor Interface, appropriate clock frequency is pro-

vided through this pin. Maximum frequency is 66 Mhz.

Write Data :

To write data into the registers, this active low signal is asserted.

Read Data:

To read data from the registers, this active low pin is asserted.

RESET

Setting this input pin "Low" resets the contents of the Command Registers to

their default settings and default operating configuration

NOTE: This pin is internally pulled up.

PMODE

Processor Mode Select:

When this pin is tied “High”, the microprocessor is operating in synchronous

mode which means that clock must be applied to the PCLK (pin 55).

Tie this pin “Low” to select the Asynchronous mode. An internal clock is pro-

vided for the microprocessor interface.

CONTROL AND ALARM INTERFACE

XRT75R06IB Datasheet(PDF) 13 Page - Exar Corporation

XRT75R06IB Datasheet(HTML) 13 Page - Exar Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Datasheet Download

Link URL