21

H7CR

H7CR

Item

Applicable Counters

Description

Setting values

Input mode

H7CR-A, H7CR-SA

Determines the input mode:

Increment keys 1 to 6 change the display.

(default)

H7CR-B, H7CR-SB

Up, Down, Reversible A, Reversible B,

H7CR-C, H7CR-SC

Reversible C

H7CR-8, H7CR-11

Press the Up key until the desired

mode is displayed.

*There is no Up or Down mode for H7CR-C

and H7CR-SC (+/– range) counters.

Output mode

H7CR-A, H7CR-SA

Determines the operation of the

Increment keys 1 to 6 change output mode.

and OUT 2

H7CR-B, H7CR-SB

control outputs. Refer to "Output

output time

H7CR-C, H7CR-SC

Operations" tables for details. Also

H7CR-8, H7CR-11

determines the output time for control

output (OUT2) in single preset

counters.

OUT 1

H7CR-B, H7CR-SB

Designates the output time for

Increment keys 1 to 6 change output time.

output time

H7CR-C, H7CR-SC

output 1 (double preset models only).

(double preset models only)

Press the increment keys to set the

desired time for output 1.

*Hold mode is available only on H7CR-BW

and H7CR-SBW counters.

(Applicable to output modes C, R, K, P, Q,

and A only.)

Counting speed

H7CR-A, H7CR-SA

Changes the input filter for counting

Increment keys 1 to 6 change count speed.

H7CR-B, H7CR-SB

inputs. Used to prevent counting

H7CR-C, H7CR-SC

errors caused by input interference.

H7CR-8, H7CR-11

Press the increment keys to set the

desired speed. A "k" on the display

indicates kilocycles (1000 cycles).

Minimum reset

H7CR-B, H7CR-SB

Determines the minimum time

Increment keys 1 to 6 change reset time.

times

H7CR-C, H7CR-SC

required for the reset input.

H7CR-8, H7CR-11

Press any increment key to switch

between 1 and 20 ms.

Item

Applicable Counters

Description

Setting values

Preset 1, H7CR-B, H7CR-SB

Determine the timing of the outputs in comparison to

Sequence when changing a digit

Preset 2 H7CR-C, H7CR-SC

the present count value according to the output mode.

using the increment keys (1 to 6).

set value

The DISPLAY key switches between set value 1 and 2 in

double preset models. Use the increment keys (1 to 6)

to change a digit.

Minus sign displayed for leftmost

digit of H7CR-C and H7CR-SC

(+/– range counters) by using

increment key 6.

s SUMMARY OF SETTING PROCEDURES

Run Mode

Settings and operation are easily achieved as shown below. The settings that are possible for each model vary. After changing modes,

the counter is ready to accept setting changes to default items.

Setting Mode

Up

Down Reversible A Reversible B Reversible C

Note: Settings changed in the Setting mode are effective only after returning to the Run mode.

1 ms

20 ms