CLC031VEC datasheet(8/31 Pages) NSC

8 / 31 page

AC Electrical Characteristics (Continued)

Note 3: Typical values are stated for VDDIO =VDDSI = +3.3V, VDDD =VDDPLL = +2.5V and TA = +25˚C.

Note 4: Spec. is guaranteed by design.

Note 5: Measured from rising-edge of first SDI cycle until Lock Detect bit goes high (true). Lock time includes CDR phase acquisition time plus PLL lock time.

Note 6: VOHV and VOLP are measured with respect to reference ground. VOLP is the peak output LOW voltage or ground bounce that may occur under dynamic

simultaneous output switching conditions. VOHV is the lowest output HIGH voltage or output droop that may occur under dynamic simultaneous output switching

conditions.

Note 7: When used to clock control data into or from the CLC031, the duty cycle restriction does not apply.

Note 8: IIH includes static current required by input pull-down devices.

Note 9: Required Input Conditions are the electrical signal conditions or component values which shall be supplied by the circuit in which this device is used in order

for it to produce the specified DC and AC electrical output characteristics.

Note 10: Functional and certain other parametric tests utilize a CLC030 as the input source to the SDI inputs of the CLC031. The CLC030 is DC coupled to the

inputs of the CLC031. Typical VIN = 800 mV, VCM = 2.9 V.

Test Loads

20020104

CLC031VEC Datasheet(PDF) 8 Page - National Semiconductor (TI)

CLC031VEC Datasheet(HTML) 8 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Datasheet Download

Link URL