AT89C51CC03U-RDTIM datasheet(108/197 Pages) ATMEL

108 / 197 page

108

AT89C51CC03

4182K–CAN–05/06

Table 49. CANGSTA Register

CANGSTA (S:AAh Read Only)

CAN General Status Register

Reset Value = x0x0 0000b

OVFG

TBSY

RBSY

ENFG

BOFF

ERRP

Bit

Number

Bit Mnemonic Description

Reserved

The values read from this bit is indeterminate. Do not set this bit.

6OVFG

Overload Frame Flag

This status bit is set by the hardware as long as the produced overload frame

is sent.

This flag does not generate an interrupt

Reserved

The values read from this bit is indeterminate. Do not set this bit.

4TBSY

Transmitter Busy

This status bit is set by the hardware as long as the CAN transmitter

generates a frame (remote, data, overload or error frame) or an ack field. This

bit is also active during an InterFrame Spacing if a frame must be sent.

This flag does not generate an interrupt.

3RBSY

Receiver Busy

This status bit is set by the hardware as long as the CAN receiver acquires or

monitors a frame.

This flag does not generate an interrupt.

2ENFG

Enable On-chip CAN Controller Flag

Because an enable/disable command is not effective immediately, this status

bit gives the true state of a chosen mode.

This flag does not generate an interrupt.

1BOFF

Bus Off Mode

see Figure 53

0ERRP

Error Passive Mode

see Figure 53

AT89C51CC03U-RDTIM Datasheet(PDF) 108 Page - ATMEL Corporation

AT89C51CC03U-RDTIM Datasheet(HTML) 108 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL