T89C51AC2 datasheet(21/29 Pages) ATMEL

21 / 29 page

A/T89C51AC2 UART Bootloader

4231C–CAN–03/05

In-Application

Programming/Self-

programming

The IAP allows to reprogram a microcontroller on-chip Flash memory without removing

it from the system and while the embedded application is running.

The user application can call some Application Programming Interface (API) routines

allowing IAP. These API are executed by the bootloader.

To call the corresponding API, the user must use a set of Flash_api routines which can

be linked with the application.

Example of Flash_api routines are available on the Atmel web site on the software appli-

cation note:

C Flash Drivers for the A/T89C51AC2

The Flash_api routines on the package work only with the UART bootloader.

The Flash_api routines are listed in APPENDIX-B.

API Call

Process

The application selects an API by setting R1, ACC, DPTR0 and DPTR1 registers.

All calls are made through a common interface “USER_CALL” at the address FFF0h.

The jump at the USER_CALL must be done by LCALL instruction to be able to come-

back in the application.

Before jump at the USER_CALL, the bit ENBOOT in AUXR1 register must be set.

Constraints

The interrupts are not disabled by the bootloader.

Interrupts must be disabled by the user prior to jump to the USER_CALL, then re-

enabled when returning.

Interrupts must also be disabled before accessing EEPROM data then re-enabled after.

The user must take care of hardware watchdog before launching a Flash operation.

For more information regarding the Flash writing time see the A/T89C51AC2 datasheet.

T89C51AC2 Datasheet(PDF) 21 Page - ATMEL Corporation