Material Tester PCE-CT 26FN

Material tester PCE-CT 26FN

For iron and non-ferrous substrates / Large measuring range / Rotatable color display / Low weight 

The material tester PCE-CT 26FN can measure non-destructive coatings (paints, plastics ...) on steel / iron and non-ferrous metals. The material

tester is ideally suited, for example, to detect accidental damage to the vehicle immediately. But also in the industrial sector, the PCE-CT 26FN

material tester is used for incoming and outgoing inspection in order to be able to offer consistently consistent product qualities.

The ergonomically shaped material tester  with integrated probe and very simple operation allows you to quickly determine measurement

results with high accuracy. The material tester PCE-CT 26FN is designed for measurements of non-magnetic coatings such as lacquer, plastic,

chrome, copper, zinc, enamel, etc. on steel and iron, as well as all insulating coatings such as lacquer, plastic, enamel, paper, glass, rubber etc.

on copper, aluminum, brass, stainless steel and aluminum.

Application / use:

Simply place the material tester u. read the measured value. You can easily measure varnish and paint layers, plastic layers, chrome layers,

copper plating, zinc layers, galvanizing, enamel ... on steel, stainless steel, iron and similar materials. Non-ferrous metals (copper, aluminum,

brass) and anodized aluminum. 

By means of the included standards you can adjust the material tester at any time. To do this, the material tester must be placed on one of the

foils. Please make sure that the meter is seated straight / level.

Immediately ready to measure

Wear-resistant sensor

V-groove for measurement on pipes

One-handed operation

ISO calibration optional

Incl. transport case