PCF8583P datasheet(16/28 Pages) PHILIPS

16 / 28 page

1997 Jul 15

Philips Semiconductors

Product speciﬁcation

Clock/calendar with 240

× 8-bit RAM

PCF8583

9I2C-BUS PROTOCOL

9.1

Addressing

Before any data is transmitted on the I2C-bus, the device which should respond is addressed first. The addressing is

always carried out with the first byte transmitted after the start procedure.

The clock/calendar acts as a slave receiver or slave transmitter. Therefore the clock signal SCL is only an input signal,

but the data signal SDA is a bidirectional line.

The clock/calendar slave address is shown in Fig.16. Bit A0 corresponds to hardware address pin A0. Connecting this

pin to VDD or VSS allows the device to have one of two different addresses.

9.2

Clock/calendar READ/WRITE cycles

The I2C-bus configuration for the different PCF8583 READ and WRITE cycles is shown in Figs 17, 18 and 19.

Fig.16 Slave address.

handbook, halfpage

MRB016

101

A0 R/W

group 1

group 2

Fig.17 Master transmits to slave receiver (WRITE) mode.

handbook, full pagewidth

SLAVE ADDRESS

WORD ADDRESS

DATA

acknowledgement

from slave

acknowledgement

from slave

acknowledgement

from slave

R/W

auto increment

memory word address

MBD822

n bytes

PCF8583P Datasheet(PDF) 16 Page - NXP Semiconductors