Low-Power Programmable Quick Turn Clock

T M

47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 12/12/06 Page 6

LAYOUT RECOMMENDATIONS

The following guidelines are to assist you with a performance optimized PCB design:

- Keep all the PCB traces to the PL611s-06 as short

as possible, as well as keeping all other traces as

far away from it as possible.

- Place a 0.01 F~0.1 F decoupling capacitor

between VDD and GND, on the component side of

the PCB, close to the VDD pin. It is not

recommended to place this component on the

backside of the PCB. Going through vias will reduce

the signal integrity, causing additional jitter and

phase noise.

- It is highly recommended to keep the VDD and

GND traces as short as possible.

- When connecting long traces (> 1 inch) to a CMOS

output, it is important to design the traces as a

transmission line or ‘stripline’, to avoid reflections or

ringing. In this case, the CMOS output needs to be

matched to the trace impedance. Usually ‘striplines’

are designed for 50

impedance and CMOS outputs

usually have lower than 50

impedance so

matching can be achieved by adding a resistor in

series with the CMOS output pin to the ‘stripline’

trace.

- Please contact PhaseLink for additional information

on how to design outputs driving long traces or for

the Gerber files for the PL611s-06 eval board shown.

DFN-6L Evaluation Board