24FC32-SLASHP datasheet(6/16 Pages) MICROCHIP

6 / 16 page

24FC32

DS21126E-page 6

 2004 Microchip Technology Inc.

4.0

WRITE OPERATION

4.1

Split Endurance

The 24FC32 is organized as a continuous 32K block of

memory. However, the first 4K, starting at address 000,

is rated at 10,000,000 E/W cycles ensured. The

remainder of the array, 28K bits, is rated at 100K E/W

cycles ensured. This feature is helpful in applications in

which some data change frequently, while a majority of

the data change infrequently. One example would be a

cellular telephone in which last-number redial and

microcontroller scratch pad require a high-endurance

block, while speed dials and lookup tables change

infrequently and so require only a standard endurance

rating.

4.2

Byte Write

Following the Start condition from the master, the

control code (four bits), the device select (three bits),

and the R/W bit which is a logic low are clocked onto

the bus by the master transmitter. This indicates to the

addressed slave receiver that a byte with a word

address

will

after

has

generated

Acknowledge bit during the ninth clock cycle. Therefore

the next byte transmitted by the master is the high-

order byte of the word address and will be written into

the address pointer of the 24FC32. The next byte is the

Least Significant Address Byte. After receiving another

Acknowledge signal from the 24FC32 the master

device will transmit the data word to be written into the

addressed

memory

location.

The

24FC32

acknowledges again and the master generates a Stop

condition. This initiates the internal write cycle, and

during this time the 24FC32 will not generate

Acknowledge signals (Figure 4-1).

4.3

Page Write

The write control byte, word address and the first data

byte are transmitted to the 24FC32 in the same way as

in a byte write. But instead of generating a Stop

condition, the master transmits up to eight pages of

eight data bytes each (64 bytes total) which are

temporarily stored in the on-chip page cache of the

24FC32. They will be written from cache into the

EEPROM array after the master has transmitted a Stop

condition. After the receipt of each word, the six lower

order address pointer bits are internally incremented by

one. The higher order seven bits of the word address

remain constant. If the master should transmit more

than eight bytes prior to generating the Stop condition

(writing across a page boundary), the address counter

(lower three bits) will roll over and the pointer will be

incremented to point to the next line in the cache. This

can continue to occur up to eight times or until the

cache is full, at which time a Stop condition should be

generated by the master. If a Stop condition is not

received, the cache pointer will roll over to the first line

(byte 0) of the cache, and any further data received will

overwrite previously captured data. The Stop condition

can be sent at any time during the transfer. As with the

byte write operation, once a Stop condition is received,

an internal write cycle will begin. The 64-byte cache will

continue to capture data until a Stop condition occurs or

the operation is aborted (Figure 4-2).

FIGURE 4-1:

BYTE WRITE

BUS ACTIVITY:

MASTER

SDA LINE

BUS ACTIVITY

CONTROL

BYTE

WORD

ADDRESS (1)

WORD

ADDRESS (0)

000

DATA

24FC32-/P Datasheet(PDF) 6 Page - Microchip Technology

24FC32-/P Datasheet(HTML) 6 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Download

Link URL