TSA1203

Application information

23/30

Caution:

Do not use the VB3 power supply (5 V) dedicated to the 74LCX573 external buffers to

supply the VB2 of the TSA1203 which cannot exceed 3.3 V.

8.7.2

Consumption adjustment

8.7.3

Single and differential inputs

The test board can be driven on a single analog input, or on differential inputs. With a single

analog input, you must use the ADT1-1WT transformer to generate a differential signal. In

this configuration, the resistors RSI6, RSI7, RSI8 for channel I (respectively RSQ6, RSQ7,

RSQ8 for channel Q) are connected as short-circuits whereas RSI5, RSI9 (respectively

RSQ5, RSQ9 for channel Q) are open circuits.

Alternatively, you can use the JI1 and JI1B differential inputs. In this case, the resistances

RSI5, RSI9 for channel I (respectively RSQ5, RSQ9 for channel Q) are connected as short-

circuits whereas RSI6, RSI7, RSI8 (respectively RSQ6, RSQ7, RSQ8 for channel Q) are

open circuits.

8.7.4

Mode selection

In order to select the channel you want to evaluate, you must set a jumper on the board in

the relevant position for the SELECT pin (see Figure 31).

The channels selected depend on the position of the jumper:

●

With the jumper connected to the upper connectors, channel I at the output is selected.

●

With the jumper connected horizontally, channel Q at the output is selected.

●

With the jumper connected to the lower connectors, both channels are selected,

relative to the clock edge.

Figure 31. Mode selection

VB2

VCCBE

2.5/3.3

GB3

GNDB3

0

VB3

VCCB3

2.5

Table 14.

Board connections for power supplies and other pins (continued)

Board marking

Connection

Internal voltage (V)

External voltage (V)

SELECT

DVCC

DGND

CLK

I channel

Q channel

I/Q channels

SELECT