PixArt Imaging Inc.

PAN3204DB

Wireless Optical Mouse Sensor

All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission

.

7

PixArt Imaging Inc.

E-mail: fae_service@pixart.com.tw

V3.0, Apr. 2008

0x05

Operation_Mode

Bit

7

6

5

4

3

2

1

0

Field

LEDsht_enh

0

1

Slp_enh

Slp2_enh

Slp2mu

Slp1mu

Wakeup

Usage

Operation_Mode register allows the user to change the operation of the mouse sensor. Shown below

are the bits, their default values, and optional values.

Operation_Mode[4:0]

“0xxxx” = Disable sleep mode

“10xxx” = Enable sleep mode1

“11xxx” = Enable sleep mode2

“11100” = Force enter sleep23

“1x010” = Force enter sleep13 (If Slp2_enh is set, the mouse sensor still enter the sleep2

automatically.)

“1x001” = Force wakeup from sleep mode3

Notes:

1. Enable sleep mode, but disable automatic entering sleep2 mode, that is, only 2 modes will be used,

normal mode and sleep1 mode. After 256 ms (±20%) not moving during normal mode, the mouse

sensor will enter sleep1 mode, and keep on sleep1 mode until moving is detected or wakeup is

asserted. Note that the entering time depends on the setting of Enter_Time register.

2. Enable sleep mode full function, which is 3 modes will be used, normal mode, sleep1 mode and

sleep2 mode. After 256 ms (±20%) not moving during normal mode, the mouse sensor will enter

sleep1 mode, and keep on sleep1 mode until moving is detected or wakeup is asserted.

And after 61 sec (±20%) not moving during sleep1 mode, the mouse sensor will enter sleep2 mode,

and keep on sleep2 mode until detect moving or force wakeup to normal mode. Note that the

entering time depends on the setting of Enter_Time register.

3. Only one of these three bits slp2mu_enh, slp1mu_enh, and wakeup can be set to 1 at the same time,

others have to be set to 0. After a period of time, the bit, which was set to 1, will be reset to 0 by

internal signal.

4. The user can clear Slp_enh/Slp2_enh bit to make the mouse sensor enter normal mode. If the user

clears Slp_enh/Slp2_enh bit during normal mode, the mouse sensor will keep its status. If the user

clears Slp_enh/Slp2_enh bit during sleep mode, the mouse sensor will enter normal mode after it

detect any movement or the user sets Wakeup bit.

Field Name

Description

LEDsht_enh

LED shutter enable/disable

0 = Disable

1 = Enable (Default)

Bit [6:5]

MUST always be 01

Slp_enh

Sleep mode enable/disable

0 = Disable

1 = Enable (Default)

Notes

Slp2_enh

Automatic enter sleep2 mode enable/disable

0 = Disable

1 = Enable (Default)